You are here
Home > Dilution > Ampicillin

AMPICILLIN

The authors make no claims of the accuracy of the information contained herein; and these suggested doses are not a substitute for clinical judgment. Neither GlobalRPh Inc. nor any other party involved in the preparation of this program shall be liable for any special, consequential, or exemplary damages resulting in whole or part from any user's use of or reliance upon this material.  PLEASE READ THE DISCLAIMER CAREFULLY BEFORE ACCESSING OR USING THIS SITE. BY ACCESSING OR USING THIS SITE, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS SET FORTH IN THE DISCLAIMER.

Usual Diluents

NS

Standard Dilutions   [Amount of drug] [Infusion volume] [Infusion rate]

[0 - 1 gram/ 50 ml] [30 minutes]
[Over 1 gram/ 100 ml] [30 minutes]

Stability / Miscellaneous

Label: REFRIGERATE.

DIRECTIONS FOR USE
Use only freshly prepared solutions. Intramuscular and intravenous injections should be administered within one hour after preparation since the potency may decrease significantly after this period.

For Intramuscular Use - Dissolve contents of a vial with the amount of Sterile Water for Injection, USP, or Bacteriostatic Water for Injection, USP, listed in the table below:

NDC 0781 Label
Claim
Recommended
Amount of
Diluent
Withdrawable
Volume
Concentration
(in mg/mL)
3400-95 125 mg 1.2 mL 1.0 mL 125 mg
3402-95 250 mg 1.0 mL 1.0 mL 250 mg
3407-95 500 mg 1.8 mL 2.0 mL 250 mg
3404-95 1 gram 3.5 mL 4.0 mL 250 mg
3408-95 2 gram 6.8 mL 8.0 mL 250 mg

While Ampicillin for Injection, USP, 1 g and 2 g, are primarily for intravenous use, they may be administered intramusculary when the 250 mg or 500 mg vials are unavailable. In such instances, dissolve in 3.5 or 6.8 mL Sterile Water for Injection, USP, or Bacteriostatic Water for Injection, USP, respectively. The resulting solution will provide a concentration of 250 mg per mL.

Ampicillin for Injection, USP, 125 mg, is intended primarily for pediatric use. It also serves as a convenient dosage form when small parenteral doses of the antibiotic are required.

For Direct Intravenous Use - Add 5 mL Sterile Water for Injection, USP, or Bacteriostatic Water for Injection, USP to the 125, 250, and 500 mg vials and administer slowly over a 3- to 5- minute period. Ampicillin for Injection, USP, 1 g or 2 g, may also be given by direct Intravenous administration. Dissolve in 7.4 or 14.8 mL Sterile Water for Injection, USP, or Bacteriostatic Water for Injection, USP, respectively, and administer slowly over at least 10 to 15 minutes. CAUTION: More rapid administration may result in convulsive seizures.

For Administration by Intravenous Drip - Reconstitute as directed above ( For Direct Intravenous Use) prior to diluting with Intravenous Solution. Stability studies on ampicillin sodium at several concentrations in various intravenous solutions indicate the drug will lose less than 10% activitiy at the temperatures noted for the time periods stated.

Stability:

Room Temperature (25° C)
Diluent Concentrations Stability
Periods
Sterile Water for Injection up to 30 mg/mL 8 hours
Isotonic Sodium Chloride up to 30 mg/mL 8 hours
5% Dextrose in Water 10 to 20 mg/mL 1 hour
5% Dextrose in Water up to   2 mg/mL 2 hours
5% Dextrose in 0.45% NaCl up to   2 mg/mL 2 hours
Lactated Ringer's Solution up to 30 mg/mL 8 hours
     
Refrigerated (4° C)
Diluent Concentrations Stability
Periods
Sterile Water for Injection 30 mg/mL 48 hours
Sterile Water for Injection up to 20 mg/mL 72 hours
Isotonic Sodium Chloride 30 mg/mL 24 hours
Isotonic Sodium Chloride up to 20 mg/mL 48 hours
Lactated Ringer's Solution up to 30 mg/mL 24 hours
5% Dextrose in Water up to 20 mg/mL 1 hour
5% Dextrose and 0.45% NaCl up to 10 mg/mL 1 hour

Only those solutions listed above should be used for the intravenous infusion of Ampicillin for injection, USP. The concentrations should fall within the range specified. The drug concentration and the rate and volume of the infusion should be adjusted so that the total dose of ampicillin is administered before the drug loses its stability in the solution in use.

Pharmacy Bulk Package– This glass vial contains 10 grams ampicillin and is designed for use in the pharmacy in preparing IV additives. Add 94 mL Sterile Water for Injection, USP. The resulting solution will contain 100 milligrams ampicillin activity per mL, and is stable up to one hour at room temperature. Diluting further within one hour from 5 mg to 10 mg per mL, the resulting solution will remain stable for 8 hours at room temperature or 72 hours under refrigeration.
CAUTION: NOT TO BE DISPENSED AS A UNIT.

DOSAGE AND ADMINISTRATION
Infections of the respiratory tract and soft tissues.
Patients weighing 40 kg (88 lbs) or more: 250 to 500 mg every 6 hours.

Patients weighing less than 40 kg (88 lbs): 25 to 50 mg/kg/day in equally divided doses at 6- to 8- hour intervals.

Infections of the gastrointestinal and genitourinary tracts (including those caused by Neisseria gonorrhoeae in females).
Patients weighing 40 kg (88 lbs) or more: 500 mg every 6 hours.

Patients weighing less than 40 kg (88 lbs): 50 mg/kg/day in equally divided doses at 6- to 8- hour intervals.

In the treatment of chronic urinary tract and intestinal infections, frequent bacteriological and clinical appraisal is necessary. Smaller doses than those recommended above should not be used. Higher doses should be used for stubborn or severe infections. In stubborn infections, therapy may be required for several weeks. It may be necessary to continue clinical and/or bacteriological follow-up for several months after cessation of therapy.

Urethritis in males due to N. gonorrhoeae.
Adults – Two doses of 500 mg each at an interval of 8 to 12 hours. Treatment may be repeated if necessary or extended if required.

In the treatment of complications of gonorrheal urethritis, such as prostatitis and epididymitis, prolonged and intensive therapy is recommended. Cases of gonorrhea with a suspected primary lesion of syphilis should have darkfield examinations before receiving treatment. In all other cases where concomitant syphilis is suspected, monthly serological tests should be made for a minimum of four months. The doses for the preceding infections may be given by either the intramuscular or intravenous route. A change to oral ampicillin may be made when appropriate.

Bacterial Meningitis
Adults and children – 150 to 200 mg/kg/day in equally divided doses every 3 to 4 hours. (Treatment may be initiated with intravenous drip therapy and continued with intramuscular injections.) The doses for other infections may be given by either the intravenous or intramuscular route.

Septicemia
Adults and children – 150 to 200 mg/kg/day. Start with intravenous administration for at least three days and continue with the intramuscular route every 3 to 4 hours.

Treatment of all infections should be continued for a minimum of 48 to 72 hours beyond the time that the patient becomes asymptomatic or evidence of bacterial eradication has been obtained. A minimum of 10-days treatment is recommended for any infection caused by Group A beta-hemolytic streptococci to help prevent the occurrence of acute rheumatic fever or acute glomerulonephritis.

HOW SUPPLIED
Ampicillin for Injection, USP for IM or IV Injection. Ampicillin sodium equivalent to 125, 250, 500 mg, 1, 2, or 10 grams ampicillin per vial.

NDC 0781-3400-95 125 mg vial packaged in 10s
NDC 0781-3402-95 250 mg vial packaged in 10s
NDC 0781-3407-95 500 mg vial packaged in 10s
NDC 0781-3404-95 1 gram vial packaged in 10s
NDC 0781-3408-95 2 gram vial packaged in 10s
NDC 0781-3409-95 10 gram Pharmacy Bulk Package packaged in 10s

Manufactured by
Sandoz GmbH, Kundl, Austria
for Sandoz Inc., Broomfield, CO 80020

Ampicillin

thpxl