DOSAGE AND ADMINISTRATION
This preparation is for intravenous use only (see WARNINGS).
Special Dispensing Information: WHEN DISPENSING VINBLASTINE SULFATE (vinblastine sulfate injection)
IN OTHER THAN THE ORIGINAL CONTAINER, IT IS IMPERATIVE THAT IT BE PACKAGED IN
THE PROVIDED OVERWRAP WHICH BEARS THE FOLLOWING STATEMENT: “DO NOT REMOVE COVERING
UNTIL MOMENT OF INJECTION. FATAL IF GIVEN INTRATHECALLY. FOR INTRAVENOUS USE
ONLY” (see WARNINGS). A syringe containing a specific dose must be labeled,
using the auxiliary sticker provided, to state: “FATAL IF GIVEN INTRATHECALLY.
FOR INTRAVENOUS USE ONLY”.
Caution: It is extremely important that the intravenous needle or catheter
be properly positioned before any vinblastine sulfate (vinblastine sulfate injection) is injected. Leakage into
surrounding tissue during intravenous administration of vinblastine sulfate (vinblastine sulfate injection)
may cause considerable irritation. If extravasation occurs, the injection should
be discontinued immediately, and any remaining portion of the dose should then
be introduced into another vein. Local injection of hyaluronidase and the application
of moderate heat to the area of leakage help disperse the drug and minimize
discomfort and the possibility of cellulitis.
There are variations in the depth of the leukopenic response which follows therapy with vinblastine sulfate (vinblastine sulfate injection) . For this reason, it is recommended that the drug be given no more frequently than once every 7 days.
Adult patients: It is wise to initiate therapy for adults by administering
a single intravenous dose of 3.7 mg/m2 of body surface area (bsa).
Thereafter, white-blood-cell counts should be made to determine the patient's
sensitivity to vinblastine sulfate (vinblastine sulfate injection) .
A simplified and conservative incremental approach to dosage at weekly intervals
for adults may be outlined as follows:
First dose ........................... 3.7 mg/m2 bsa
Second dose ...................... 5.5 mg/m2 bsa
Third dose .......................... 7.4 mg/m2 bsa
Fourth dose ........................ 9.25 mg/m2 bsa
Fifth dose ........................... 11.1 mg/m2 bsa
The above-mentioned increases may be used until a maximum dose not exceeding
18.5 mg/m2 bsa for adults is reached. The dose should not be increased
after that dose which reduces the white-cell count to approximately 3000 cells/mm3.
In some adults, 3.7 mg/m2 bsa may produce this leukopenia; other
adults may require more than 11.1 mg/m2 bsa; and, very rarely, as
much as 18.5 mg/m2 bsa may be necessary. For most adult patients,
however, the weekly dosage will prove to be 5.5 to 7.4 mg/m2 bsa.
When the dose of vinblastine sulfate (vinblastine sulfate injection) which will produce the above degree of
leukopenia has been established, a dose of 1 increment smaller than this
should be administered at weekly intervals for maintenance. Thus, the patient
is receiving the maximum dose that does not cause leukopenia. It should
be emphasized that, even though 7 days have elapsed, the next dose of vinblastine
sulfate should not be given until the white-cell count has returned to at least
4000/mm3. In some cases, oncolytic activity may be encountered
before leukopenic effect. When this occurs, there is no need to increase the
size of the subsequent doses (See PRECAUTIONS).
Pediatric Patients: A review of published literature from 1993 to 1995
showed that initial doses of vinblastine sulfate (vinblastine sulfate injection) in pediatric patients varied
depending on the schedule used and whether vinblastine sulfate (vinblastine sulfate injection) was administered
as a single agent or incorporated within a particular chemotherapeutic regimen.
As a single agent for Letterer-Siwe disease (histiocytosis X), the initial dose
of vinblastine sulfate (vinblastine sulfate injection) was reported as 6.5 mg/m2. When vinblastine
sulfate was used in combination with other chemotherapeutic agents for the treatment
of Hodgkin's disease, the initial dose was reported as 6 mg/m2. For
testicular germ cell carcinomas, the initial dose of vinblastine sulfate (vinblastine sulfate injection) was
reported as 3 mg/m2 in a combination regimen. Dose modifications
should be guided by hematologic tolerance.
Patients with Renal or Hepatic Impairment: A reduction of 50% in the
dose of vinblastine sulfate (vinblastine sulfate injection) is recommended for patients having a direct serum
bilirubin value above 3 mg/100 mL. Since metabolism and excretion are primarily
hepatic, no modification is recommended for patients with impaired renal function.
The duration of maintenance therapy varies according to the disease being treated and the combination of antineoplastic agents being used. There are differences of opinion regarding the duration of maintenance therapy with the same protocol for a particular disease; for example, various durations have been used with the MOPP program in treating Hodgkin's disease. Prolonged chemotherapy for maintaining remissions involves several risks, among which are life-threatening infectious diseases, sterility, and possibly the appearance of other cancers through suppression of immune surveillance.
In some disorders, survival following complete remission may not be as prolonged as that achieved with shorter periods of maintenance therapy. On the other hand, failure to provide maintenance therapy in some patients may lead to unnecessary relapse; complete remissions in patients with testicular cancer, unless maintained for at least 2 years, often result in early relapse.
To prepare a solution containing 1 mg/mL of vinblastine sulfate (vinblastine sulfate injection) , add 10 mL of Bacteriostatic Sodium Chloride Injection (preserved with benzyl alcohol) or 10 mL of Sodium Chloride Injection (unpreserved) to the 10 mg of Vinblastine Sulfate (vinblastine sulfate injection) for Injection in the sterile vial. Do not use other solutions. The drug dissolves instantly to give a clear solution.
Unused portions of the remaining solutions made with normal saline that do not contain preservatives should be discarded immediately. Unused preservative-containing solutions made with normal saline may be stored in a refrigerator for future use for a maximum of 28 days.
The dose of vinblastine sulfate (vinblastine sulfate injection) (calculated to provide the desired amount) may be injected either into the tubing of a running intravenous infusion or directly into a vein. The latter procedure is readily adaptable to outpatient therapy. In either case, the injection may be completed in about 1 minute. If care is taken to insure that the needle is securely within the vein and that no solution containing vinblastine sulfate (vinblastine sulfate injection) is spilled extravascularly, cellulitis and/or phlebitis will not occur. To minimize further the possibility of extravascular spillage, it is suggested that the syringe and needle be rinsed with venous blood before withdrawal of the needle. The dose should not be diluted in large volumes of diluent (i.e., 100 to 250 mL) or given intravenously for prolonged periods (ranging from 30 to 60 minutes or more), since this frequently results in irritation of the vein and increases the chance of extravasation.
Because of the enhanced possibility of thrombosis, it is considered inadvisable
to inject a solution of vinblastine sulfate (vinblastine sulfate injection) into an extremity in which the circulation
is impaired or potentially impaired by such conditions as compressing or invading
neoplasm, phlebitis, or varicosity.
Note: Parenteral drug products should be inspected visually for particulate
matter and discoloration prior to administration, whenever solution and container
permit.
Procedures for proper handling and disposal of anti-cancer drugs should be
considered. Several guidelines on this subject have been published.1-7
There is no general agreement that all of the procedures recommended in the
guidelines are necessary or appropriate.
HOW SUPPLIED
Vinblastine Sulfate for Injection USP (vinblastine sulfate (vinblastine sulfate injection) injection) is supplied in packs of ten individually-boxed
vials containing 10 mg lyophilized vinblastine sulfate (vinblastine sulfate injection) .
NDC 55390-091-10.
Store vials in refrigerator, 2° to 8°C (36° to 46°F) to assure extended stability.
REFERENCES
1. Recommendations for the Safe Handling of Parenteral Antineoplastic Drugs,
NIH Publication No. 83-2621. For sale by the Superintendent of Documents, U.S.
Government Printing Office, Washington, DC 20402.
2. AMA Council Report, Guidelines for Handling Parenteral Antineoplastics.
JAMA,1985; 253 (11) :1590-1592.
3. National Study Commission on Cytotoxic Exposure – Recommendations for Handling
Cytotoxic Agents. Available from Louis P. Jeffrey, ScD., Chairman, National
Study Commission on Cytotoxic Exposure, Massachusetts College of Pharmacy and
Allied Health Sciences, 179 Longwood Avenue, Boston, Massachusetts 02115.
4. Clinical Oncological Society of Australia, Guidelines and Recommendations
for Safe Handling of Antineoplastic Agents. Med J Australia, 1983; 1:426-428.
5. Jones RB, et al: Safe Handling of Chemotherapeutic Agents: A Report from
the Mount Sinai Medical Center. CA – A Cancer Journal for Clinicians,1983;
(Sept/Oct) 258-263.
6. American Society of Hospital Pharmacists Technical Assistance Bulletin on
Handling Cytotoxic and Hazardous Drugs. Am J. Hosp Pharm,1990; 47:1033-1049.
7. OSHA Work-Practice Guidelines for Personnel Dealing with Cytotoxic (Antineoplastic)
Drugs. Am J. Hosp Pharm, 1986; 43:1193-1204.
Manufactured by: Ben Venue Laboratories Bedford, OH 44146. Manufactured
for: Bedford Laboratories Bedford, Ohio 44146. FDA Rev date: 8/22/2002