INDICATIONS
Vecuronium bromide is indicated as an adjunct to general anesthesia, to facilitate endotracheal intubation and to provide
skeletal muscle relaxation during surgery or mechanical ventilation.
DOSAGE AND ADMINISTRATION
Vecuronium bromide for injection is for intravenous use only.
This drug should be administered by or under the supervision of experienced clinicians familiar with the use of neuromuscular
blocking agents. Dosage must be individualized in each case. The dosage information which follows is derived from studies
based upon units of drug per unit of body weight and is intended to serve as a guide only, especially regarding enhancement of
neuromuscular blockade of vecuronium by volatile anesthetics and by prior use of succinylcholine (see DRUG INTERACTIONS). Parenteral drug products should be inspected visually for particulate matter and discoloration prior to
administration whenever solution and container permit.
To obtain maximum clinical benefits of vecuronium and to minimize the possibility of overdosage, the monitoring of muscle
twitch response to peripheral nerve stimulation is advised.
The recommended initial dose of vecuronium bromide is 0.08 to 0.1 mg/kg (1.4 to 1.75 times the ED90) given as an
intravenous bolus injection. This dose can be expected to produce good or excellent non-emergency intubation conditions in
2.5 to 3 minutes after injection. Under balanced anesthesia, clinically required neuromuscular blockade lasts approximately 25-
30 minutes, with recovery to 25% of control achieved approximately 25 to 40 minutes after injection and recovery to 95% of
control achieved approximately 45-65 minutes after injection. In the presence of potent inhalation anesthetics, the
neuromuscular blocking effect of vecuronium is enhanced. If vecuronium is first administered more than 5 minutes after the
start of inhalation agent or when steady-state has been achieved, the initial vecuronium bromide dose may be reduced by
approximately 15%, i.e., 0.06 to 0.085 mg/kg.
Prior administration of succinylcholine may enhance the neuromuscular blocking effect and duration of action of vecuronium. If
intubation is performed using succinylcholine, a reduction of initial dose of vecuronium bromide to 0.04 to 0.06 mg/kg with
inhalation anesthesia and 0.05 to 0.06 mg/kg with balanced anesthesia may be required.
During prolonged surgical procedures, maintenance doses of 0.01 to 0.015 mg/kg of vecuronium bromide are recommended;
after the initial vecuronium bromide injection, the first maintenance dose will generally be required within 25 to 40 minutes.
However, clinical criteria should be used to determine the need for maintenance doses.
Since vecuronium lacks clinically important cumulative effects, subsequent maintenance doses, if required, may be
administered at relatively regular intervals for each patient, ranging approximately from 12 to 15 minutes under balanced
anesthesia, slightly longer under inhalation agents. (If less frequent administration is desired, higher maintenance doses may
be administered.)
Should there be reason for the selection of larger doses in individual patients, initial doses ranging from 0.15 mg/kg up to 0.28
mg/kg have been administered during surgery under halothane anesthesia without ill effects to the cardiovascular system
being noted as long as ventilation is properly maintained (see CLINICAL PHARMACOLOGY).
Use By Continuous Infusion
After an intubating dose of 80 to 100 mcg/kg, a continuous infusion of 1 mcg/kg/min can be initiated approximately 20-40 min
later. Infusion of vecuronium should be initiated only after early evidence of spontaneous recovery from the bolus dose. Longterm
intravenous infusion to support mechanical ventilation in the intensive care unit has not been studied sufficiently to
support dosage recommendations (see PRECAUTIONS).
The infusion of vecuronium should be individualized for each patient. The rate of administration should be adjusted according
to the patient's twitch response as determined by peripheral nerve stimulation. An initial rate of 1 mcg/kg/min is recommended,
with the rate of the infusion adjusted thereafter to maintain a 90% suppression of twitch response. Average infusion rates may
range from 0.8 to 1.2 mcg/kg/min.
Inhalation anesthetics, particularly enflurane and isoflurane may enhance the neuromuscular blocking action of nondepolarizing
muscle relaxants. In the presence of steady-state concentrations of enflurane or isoflurane, it may be necessary to reduce the
rate of infusion 25-60 percent, 45-60 min after the intubating dose. Under halothane anesthesia it may not be necessary to
reduce the rate of infusion.
Spontaneous recovery and reversal of neuromuscular blockade following discontinuation of vecuronium infusion may be
expected to proceed at rates comparable to that following a single bolus dose (see CLINICAL PHARMACOLOGY).
Infusion solutions of vecuronium can be prepared by mixing vecuronium with an appropriate infusion solution such as Dextrose
Injection 5%, Sodium Chloride Injection 0.9%, Dextrose (5%) and Sodium Chloride Injection, or Lactated Ringer's Injection.
Unused portions of infusion solutions should be discarded.
Infusion rates of vecuronium bromide can be individualized for each patient using the following table:
Drug
Delivery
Rate
(mcg/kg/min) |
Infusion
Delivery Rate
(mL/kg/min) |
0.1
mg/mL* |
0.2
mg/m† |
0.7 |
0.007 |
0.0035 |
0.8 |
0.008 |
0.004 |
0.9 |
0.009 |
0.0045 |
1 |
0.01 |
0.005 |
1.1 |
0.011 |
0.0055 |
1.2 |
0.012 |
0.006 |
1.3 |
0.013 |
0.0065 |
* 10 mg of vecuronium bromide in 100 mL solution
†20 mg of vecuronium bromide in 100 mL solution |
The following table is guideline for mL/min delivery for a solution of 0.1 mg/mL (10 mg in 100 mL) with an infusion pump.
Vecuronium Bromide Infusion Rate - mL/min
Amount of Drug
mcg/kg/min |
Patient Weight - kg |
40 |
50 |
60 |
70 |
80 |
90 |
100 |
0.7 |
0.28 |
0.35 |
0.42 |
0.49 |
0.56 |
0.63 |
0.7 |
0.8 |
0.32 |
0.4 |
0.48 |
0.56 |
0.64 |
0.72 |
0.8 |
0.9 |
0.36 |
0.45 |
0.54 |
0.63 |
0.72 |
0.81 |
0.9 |
1 |
0.4 |
0.5 |
0.6 |
0.7 |
0.8 |
0.9 |
1 |
1.1 |
0.44 |
0.55 |
0.66 |
0.77 |
0.88 |
0.99 |
1.1 |
1.2 |
0.48 |
0.6 |
0.72 |
0.84 |
0.96 |
1.08 |
1.2 |
1.3 |
0.52 |
0.65 |
0.78 |
0.91 |
1.04 |
1.17 |
1.3 |
NOTE
If a concentration of 0.2 mg/mL is used (20 mg in 100 mL), the rate should be decreased by one-half.
USE In Pediatric Patients
Older pediatric patients (10 to 16 years of age) have approximately the same dosage requirements (mg/kg) as adults and may
be managed the same way. Younger pediatric patients (1 to 10 years of age) may require a slightly higher initial dose and may
also require supplementation slightly more often than adults.
Infants under one year of age but older than 7 weeks are moderately more sensitive to vecuronium on a mg/kg basis than
adults and take about 1½ times as long to recover. See also subsection of PRECAUTIONS titled Pediatric Use. Information
presently available does not permit recommendation on usage in pediatric patients less than 7 weeks of age (see PRECAUTIONS). There are insufficient data concerning continuous infusion of vecuronium in pediatric patients, therefore, no
dosing recommendations can be made.
Compatibility
Vecuronium bromide is compatible in solution with:
Sodium Chloride Injection 0.9%
Dextrose Injection 5%
Sterile Water for Injection
Dextrose (5%) and Sodium Chloride 0.9% Injection
Lactated Ringer's Injection
Use within 24 hours of mixing with the above solutions.
Vecuronium bromide is also compatible in solution with:
Bacteriostatic Water for Injection (NOT FOR USE IN NEWBORNS). Use within 5 days of mixing with the above solution.
Reconstituted vecuronium bromide, which has an acid pH, should not be mixed with alkaline solutions (e.g., barbiturate
solutions such as thiopental) in the same syringe or administered simultaneously during intravenous infusion through the same
needle or through the same intravenous line.
After Reconstitution
see DOSAGE AND ADMINISTRATION - Compatibility: for diluents compatible with Vecuronium Bromide for Injection.
- When reconstituted with bacteriostatic water for injection: CONTAINS BENZYL ALCOHOL, WHICH IS NOT INTENDED
FOR USE IN NEWBORNS. Use within 5 days. May be stored at room temperature or refrigerated.
- When reconstituted with sterile water for injection or other compatible I.V. solutions not containing an antimicrobial
preservative (e.g., sterile water for injection): Refrigerate vial. Use within 24 hours. Single use only. Discard unused portion.
Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever
solution and container permit.
HOW SUPPLIED
NDC No. |
Description |
0409-1632-01 |
10 mg vecuronium bromide in 10 mL Fliptop vials. DILUENT NOT SUPPLIED |
0409-1634-01 |
20 mg vecuronium bromide in 25 mL Fliptop vials. DILUENT NOT SUPPLIED |
Store dry powder at 20 to 25°C (68 to 77°F). [See USP Controlled Room Temperature.] Protect from light.
Manufactured By Hospira, Inc., Lake Forest, IL 60045 USA. Revised: Sep 2016