DOSAGE AND ADMINISTRATION
Rifampin can be administered by the oral route or by IV
infusion (see INDICATIONS AND USAGE). IV doses are the same as those for
oral.
See CLINICAL PHARMACOLOGY for dosing information
in patients with renal failure.
Tuberculosis
Adults
10 mg/kg, in a single daily administration, not
to exceed 600 mg/day, oral or IV
Pediatric Patients
10-20 mg/kg, not to exceed 600
mg/day, oral or IV
It is recommended that oral rifampin be administered once
daily, either 1 hour before or 2 hours after a meal with a full glass of water.
Rifampin is indicated in the treatment of all forms of
tuberculosis. A three-drug regimen consisting of rifampin, isoniazid, and
pyrazinamide (e.g., RIFATER®) is recommended in the initial phase of
short-course therapy which is usually continued for 2 months. The Advisory
Council for the Elimination of Tuberculosis, the American Thoracic Society, and
the Centers for Disease Control and Prevention recommend that either
streptomycin or ethambutol be added as a fourth drug in a regimen containing
isoniazid (INH), rifampin, and pyrazinamide for initial treatment of tuberculosis
unless the likelihood of INH resistance is very low. The need for a fourth drug
should be reassessed when the results of susceptibility testing are known. If
community rates of INH resistance are currently less than 4%, an initial
treatment regimen with less than four drugs may be considered.
Following the initial phase, treatment should be
continued with rifampin and isoniazid (e.g., RIFAMATE®) for at least 4 months.
Treatment should be continued for longer if the patient is still sputum or
culture positive, if resistant organisms are present, or if the patient is HIV
positive.
Preparation Of Solution For IV Infusion
Reconstitute the lyophilized powder by transferring 10 mL
of sterile water for injection to a vial containing 600 mg of rifampin for
injection. Swirl vial gently to completely dissolve the antibiotic. The
reconstituted solution contains 60 mg rifampin per mL and is stable at room
temperature for up to 30 hours. Prior to administration, withdraw from the
reconstituted solution a volume equivalent to the amount of rifampin calculated
to be administered and add to 500 mL of infusion medium. Mix well and infuse at
a rate allowing for complete infusion within 3 hours. Alternatively, the amount
of rifampin calculated to be administered may be added to 100 mL of infusion
medium and infused in 30 minutes.
Dilutions in dextrose 5% for injection (D5W) are stable
at room temperature for up to 8 hours and should be prepared and used within
this time. Precipitation of rifampin from the infusion solution may occur
beyond this time. Dilutions in normal saline are stable at room temperature for
up to 6 hours and should be prepared and used within this time. Other infusion
solutions are not recommended.
Incompatibilities
Physical incompatibility (precipitate) was observed with
undiluted (5 mg/mL) and diluted (1 mg/mL in normal saline) diltiazem hydrochloride
and rifampin (6 mg/mL in normal saline) during simulated Y-site administration.
Meningococcal Carriers
Adults
For adults, it is recommended that 600 mg rifampin be
administered twice daily for two days.
Pediatric Patients
Pediatric patients 1 month of age or older: 10 mg/kg (not
to exceed 600 mg per dose) every 12 hours for two days.
Pediatric patients under 1 month of age: 5 mg/kg every 12
hours for two days.
Preparation Of Extemporaneous Oral Suspension
For pediatric and adult patients in whom capsule
swallowing is difficult or where lower doses are needed, a liquid suspension
may be prepared as follows:
RIFADIN 1% w/v suspension (10 mg/mL) can be compounded
using one of four syrups–Simple Syrup (Syrup NF), Simple Syrup (Humco
Laboratories), SyrPalta® Syrup (Emerson Laboratories), or Raspberry Syrup
(Humco Laboratories).
Empty the contents of four RIFADIN 300 mg capsules or
eight RIFADIN 150 mg capsules onto a piece of weighing paper.
If necessary, gently crush the capsule contents with a
spatula to produce a fine powder.
Transfer the rifampin powder blend to a 4-ounce amber
glass or plastic (high density polyethylene [HDPE], polypropylene, or
polycarbonate) prescription bottle.
Rinse the paper and spatula with 20 mL of one of the above-mentioned
syrups, and add the rinse to the bottle. Shake vigorously.
Add 100 mL of syrup to the bottle and shake vigorously.
This compounding procedure results in a 1% w/v suspension
containing 10 mg rifampin/mL. Stability studies indicate that the suspension is
stable when stored at room temperature (25±3°C) or in a refrigerator (2-8°C)
for four weeks. This extemporaneously prepared suspension must be shaken well
prior to administration.
HOW SUPPLIED
150 mg maroon and scarlet capsules imprinted
“RIFADIN 150.” Bottles of 30 (NDC 0068-0510-30)
300 mg maroon and scarlet capsules imprinted
“RIFADIN 300.” Bottles of 60 (NDC 0068-0508-60)
Storage
Store at 25°C (77°F); excursions permitted to 15-30°C
(59-86°F) [see USP Controlled Room Temperature]. Keep tightly closed.
Store in a dry place. Avoid excessive heat.
RIFADIN IV (rifampin for injection USP) is available in
sterile glass vials containing 600 mg rifampin (NDC 0068-0597-01).
Storage
Store at 25°C (77°F); excursions permitted to 15-30°C
(59-86°F) [see USP Controlled Room Temperature]. Avoid excessive heat
(temperatures above 40°C or 104°F). Protect from light.
REFERENCES
1. Clinical Laboratory Standards Institute.
Susceptibility Testing of Mycobacteria, Nocardiae, and Other Aerobic
Actinomycetes; Approved Standard CLSI Document M24-A, Vol. 23, No. 18, CLSI,
Villanova, PA, 2003.
2. Clinical Laboratory Standards Institute. Methods for
Dilution Antimicrobial Susceptibility Tests for Bacteria that Grow Aerobically
--Eighth Edition. Approved Standard CLSI Document M7-A8, Vol. 29, No. 2, CLSI,
Villanova, PA, January 2009.
3. Clinical Laboratory Standards Institute. Performance
Standards for Antimicrobial Disk Susceptibility Tests --Tenth Edition. Approved
Standard CLSI Document M2-A10, Vol. 29, No. 1, CLSI, Villanova, PA, January
2009.
4. Clinical Laboratory Standards Institute. Performance
Standards for Antimicrobial Susceptibility Testing; Twentieth Informational
Supplement, CLSI Document M100-S20, Vol. 30, No. 1, CLSI, Villanova, PA,
January 2010.
Rifadin capsules are manufactured for: sanofi-aventis
U.S. LLC Bridgewater, NJ 08807 A SANOFI COMPANY. Rifadin IV (rifampin for
injection USP) is manufactured by: sanofi-aventis U.S. LLC Bridgewater, NJ
08807 A SANOFI COMPANY. Revised : Feb 2019