CLINICAL PHARMACOLOGY
Orally administered erythromycin base and its salts are
readily absorbed in the microbiologically active form. Interindividual
variations in the absorption of erythromycin are, however, observed, and some
patients do not achieve optimal serum levels. Erythromycin is largely bound to
plasma proteins. After absorption, erythromycin diffuses readily into most body
fluids. In the absence of meningeal inflammation, low concentrations are normally
achieved in the spinal fluid but the passage of the drug across the blood-brain
barrier increases in meningitis. Erythromycin crosses the placental barrier,
but fetal plasma levels are low. The drug is excreted in human milk.
Erythromycin is not removed by peritoneal dialysis or hemodialysis.
In the presence of normal hepatic function, erythromycin is
concentrated in the liver and is excreted in the bile; the effect of hepatic
dysfunction on biliary excretion of erythromycin is not known. After oral administration,
less than 5% of the administered dose can be recovered in the active form in
the urine.
The erythromycin particles in PCE tablets are coated with a
polymer whose dissolution is pH dependent. This coating allows for minimal
release of erythromycin in acidic environments, e.g., stomach. This delivery
system is designed for optimal drug release and absorption in the small
intestine. In multiple-dose, steady-state studies, PCE tablets have
demonstrated rapid and generally adequate drug delivery in both fasting and
nonfasting conditions. However, the presence of food results in lower blood
levels, and optimal blood levels are obtained when PCE tablets are given in the
fasting state (at least ½ hour and preferably 2 hours before meals). Bioavailability
data are available from Arbor Pharmaceuticals.
Microbiology
Erythromycin acts by inhibition of protein synthesis by
binding 50 S ribosomal subunits of susceptible organisms. It does not affect
nucleic acid synthesis. Antagonism has been demonstrated in vitro between
erythromycin and clindamycin, lincomycin, and chloramphenicol.
Many strains of Haemophilus influenza are resistant
to erythromycin alone but are susceptible to erythromycin and sulfonamides used
concomitantly.
Staphylococci resistant to erythromycin may emerge during a
course of erythromycin therapy.
Erythromycin has been shown to be active against most
strains of the following microorganisms, both in vitro and in clinical
infections as described in the INDICATIONS AND USAGE section.
Gram-positive organisms
Corynebacterium diphtheriae
Corynebacterium minutissimum
Listeria monocytogenes
Staphylococcus aureus (resistant organisms may emerge
during treatment)
Streptococcus pneumoniae
Streptococcus pyogenes
Gram-negative organisms
Bordetella pertussis
Legionella pneumophila
Neisseria gonorrhoeae
Other microorganisms
Chlamydia trachomatis
Entamoeba histolytica
Mycoplasma pneumoniae
Treponema pallidum
Ureaplasma urealyticum
The following in vitro data are available, but their
clinical significance is unknown.
Erythromycin exhibits in vitro minimal inhibitory
concentrations (MIC's) of 0.5 μg/mL or less against most ( ≥ 90%)
strains of the following microorganisms; however, the safety and effectiveness
of erythromycin in treating clinical infections due to these microorganisms
have not been established in adequate and well-controlled clinical trials.
Gram-positive organisms
Viridans group streptococci
Gram-negative organisms
Moraxella catarrhalis
Susceptibility Tests
Dilution Techniques
Quantitative methods are used to determine antimicrobial
minimum inhibitory concentrations (MIC's). These MIC's provide estimates of the
susceptibility of bacteria to antimicrobial compounds. The MIC's should be
determined using a standardized procedure. Standardized procedures are based on
a dilution method1,2 (broth or agar) or equivalent with standardized
inoculum concentrations and standardized concentrations of erythromycin powder.
The MIC values should be interpreted according to the following criteria:
For Staphylococcus spp:
MIC (μg/mL) |
Interpretation |
≤ 0.5 |
Susceptible (S) |
1-4 |
Intermediate (I) |
≥ 8 |
Resistant (R) |
For Streptococcus spp. and Streptococcus
pneumoniae:
MIC (μg/mL) |
Interpretation |
≤ 0.25 |
Susceptible (S) |
0.5 |
Intermediate (I) |
≥ 1 |
Resistant (R) |
A report of
“Susceptible” indicates that the pathogen is likely to be inhibited
if the antimicrobial compound in the blood reaches the concentrations usually
achievable. A report of “Intermediate” indicates that the result
should be considered equivocal, and, if the microorganism is not fully
susceptible to alternative, clinically feasible drugs, the test should be
repeated. This category implies possible clinical applicability in body sites
where the drug is physiologically concentrated or in situations where high
dosage of drug can be used. This category also provides a buffer zone which
prevents small uncontrolled technical factors from causing major discrepancies
in interpretation. A report of “Resistant” indicates that the
pathogen is not likely to be inhibited if the antimicrobial compound in the
blood reaches the concentrations usually achievable; other therapy should be
selected.
Standardized susceptibility test procedures
require the use of laboratory control microorganisms to control the technical
aspects of the laboratory procedures. Standard erythromycin powder should
provide the following MIC values:
Microorganism |
MIC (μg/mL) |
S. aureus ATCCa 29213 |
0.25-1 |
E. faecalis ATCC 29212 |
1-4 |
S. pneumoniae ATCC 49619 |
0.03-0.12 |
aATCC is a registered trademark of the American Type
Culture Collection |
Diffusion Techniques
Quantitative methods that require
measurement of zone diameters also provide reproducible estimates of the
susceptibility of bacteria to antimicrobial compounds. One such standardized
procedure2,3 requires the use of standardized inoculum
concentrations. This procedure uses paper disks impregnated with 15-μg
erythromycin to test the susceptibility of microorganisms to erythromycin.
Reports from the laboratory
providing results of the standard single-disk susceptibility test with a
15-μg erythromycin disk should be interpreted according to the following
criteria:
For Staphylococcus spp:
Zone Diameter (mm) |
Interpretation |
≥ 23 |
Susceptible (S) |
14-22 |
Intermediate (I) |
≤ 13 |
Resistant (R) |
For Streptococcus spp. and Streptococcus
pneumoniae:
Zone Diameter (mm) |
Interpretation |
≥ 21 |
Susceptible (S) |
16-20 |
Intermediate (I) |
≤ 15 |
Resistant (R) |
Interpretation should be as stated
above for results using dilution techniques. Interpretation involves
correlation of the diameter obtained in the disk test with the MIC for
erythromycin.
As with standardized dilution
techniques, diffusion methods require the use of laboratory control
microorganisms that are used to control the technical aspects of the laboratory
procedures. For the diffusion technique, the 15-μg erythromycin disk
should provide the following zone diameters in these laboratory test quality
control strains:
Microorganism |
Zone Diameter (mm) |
S. aureus ATCC 25923 |
22-30 |
S. pneumoniae ATCC 49619 |
25-30 |
REFERENCES
1. Clinical and Laboratory Standards Institute. Methods for
Dilution Antimicrobial Susceptibility Tests for Bacteria that Grow Aerobically,
7th ed. Approved Standard, CLSI Document M07-A7, Vol. 26(2). CLSI, Wayne, PA,
Jan. 2006.
2. Clinical and Laboratory Standards Institute. Performance
Standards for Antimicrobial Susceptibility Testing, 18th Informational
Supplement, CLSI Document M100-S18, Vol 28(1). CLSI, Wayne, PA, Jan. 2008.
3. Clinical and Laboratory Standards Institute. Performance
Standards for Antimicrobial Disk Susceptibility Tests, 9th ed. Approved
Standard CLSI Document M02-A9, Vol. 26(1). CLSI, Wayne, PA, Jan. 2006.