CLINICAL PHARMACOLOGY
Orally administered erythromycin ethylsuccinate suspension
is readily and reliably absorbed under both fasting and nonfasting conditions.
Erythromycin diffuses readily into most body fluids. Only
low concentrations are normally achieved in the spinal fluid, but passage of
the drug across the blood-brain barrier increases in meningitis. In the
presence of normal hepatic function, erythromycin is concentrated in the liver
and excreted in the bile; the effect of hepatic dysfunction on excretion of
erythromycin by the liver into the bile is not known. Less than 5 percent of
the orally administered dose of erythromycin is excreted in active form in the
urine.
Erythromycin crosses the placental barrier, but fetal plasma
levels are low. The drug is excreted in human milk.
Microbiology
Erythromycin acts by inhibition of protein synthesis by
binding 50Sribosomal subunits of susceptible organisms. It does not affect
nucleic acid synthesis. Antagonism has been demonstrated in vitro between
erythromycin and clindamycin, lincomycin, and chloramphenicol.
Many strains of Haemophilus influenza are resistant to
erythromycin alone but are susceptible to erythromycin and sulfonamides used
concomitantly.
Staphylococci resistant to erythromycin may emerge during a
course of therapy.
Erythromycin has been shown to be active against most
strains of the following microorganisms, both in vitro and in clinical infections
as described in the INDICATIONS AND USAGE section.
Gram-positive Organisms
Corynebacterium diphtheriae
Corynebacterium minutissimum
Listeria monocytogenes
Staphylococcus aureus (resistant organisms may emerge
during treatment)
Streptococcus pneumoniae
Streptococcus pyogenes
Gram-negative Organism
Bordetella pertussis
Legionella pneumophila
Neisseria gonorrhoeae
Other Microorganisms
Chlamydia trachomatis
Entamoebahistolytica
Mycoplasma pneumoniae
Treponemapallidum
Urea plasma urealyticum
The following in vitro data are available.
Erythromycin exhibits in vitro minimal inhibitory
concentrations (MIC's) of 0.5 μg/mL or less against most ( ≥ 90%)
strains of the following microorganisms; however, the safety and effectiveness
of erythromycin in treating clinical infections due to these microorganisms
have not been established in adequate and well-controlled clinical trials.
Gram-positive Organisms
Viridans group streptococci
Gram-negative Organisms
Moraxella catarrhalis
Susceptibility Tests
Dilution Techniques
Quantitative methods are used to
determine antimicrobial minimum inhibitory concentrations (MIC's). These MIC's
provide estimates of the susceptibility of bacteria to antimicrobial compounds.
The MIC's should be determined using a standardized procedure. Standardized
procedures are based on a dilution method1,2 (broth or agar) or
equivalent with standardized inoculum concentrations and standardized
concentrations of erythromycin powder. The MIC values should be interpreted
according to the following criteria:
For Staphylococcus spp
MIC (μg/mL) |
Interpretation |
≤ 0.5 |
Susceptible (S) |
1 – 4 |
Intermediate (I) |
≥ 8 |
Resistant (R) |
For Streptococcus spp. and
Streptococcus pneumoniae
MIC (μg/mL) |
Interpretation |
≤ 0.25 |
Susceptible (S) |
0.5 |
Intermediate (I) |
≥ 1 |
Resistant (R) |
A report of “Susceptible” indicates that the pathogen is likely to be inhibited
if the antimicrobial compound in the blood reaches the concentrations usually
achievable. A report of “Intermediate” indicates that the result
should be considered equivocal, and, if the microorganism is not fully
susceptible to alternative, clinically feasible drugs, the test should be
repeated. This category implies possible clinical applicability in body sites
where the drug is physiologically concentrated or in situations where high
dosage of drug can be used. This category also provides a buffer zone which
prevents small uncontrolled technical factors from causing major discrepancies
in interpretation. A report of “Resistant” indicates that the
pathogen is not likely to be inhibited if the antimicrobial compound in the
blood reaches the concentrations usually achievable; other therapy should be
selected.
Standardized susceptibility test
procedures require the use of laboratory control microorganisms to control the
technical aspects of the laboratory procedures. Standard erythromycin powder
should provide the following MIC values:
Microorganism |
MIC (μg/mL) |
S. aureus ATCCa29213 |
0.25-1 |
E. faecalis ATCC 29212 |
1-4 |
S. pneumoniae ATCC 49619 |
0.03-0.12 |
aATCC is a registered trademark of the American Type Culture
Collection |
Diffusion Techniques
Quantitative methods that require
measurement of zone diameters also provide reproducible estimates of the
susceptibility of bacteria to antimicrobial compounds. One such standardized
procedure requires the use of standardized inoculum concentrations. This
procedure uses paper disks impregnated with 15-μg erythromycin to test the
susceptibility of microorganisms to erythromycin.
Reports from the laboratory
providing results of the standard single-disk susceptibility test with a
15-μg erythromycin disk should be interpreted according to the following
criteria:
For Staphylococcus spp
Zone Diameter (mm) |
Interpretation |
≥ 23 |
Susceptible (S) |
14 – 22 |
Intermediate (I) |
≤ 13 |
Resistant (R) |
For Streptococcus spp. and Streptococcus pneumoniae
Zone Diameter (mm) |
Interpretation |
≥ 21 |
Susceptible (S) |
16 – 20 |
Intermediate (I) |
≤ 15 |
Resistant (R) |
Interpretation should be as stated
above for results using dilution techniques. Interpretation involves
correlation of the diameter obtained in the disk test with the MIC for
erythromycin.
As with standardized dilution
techniques, diffusion methods require the use of laboratory control
microorganisms that are used to control the technical aspects of the laboratory
procedures. For the diffusion technique, the 15-μg erythromycin disk
should provide the following zone diameters in these laboratory test quality
control strains:
Microorganism |
Zone Diameter(mm) |
S. aureus ATCC 25923 |
22-30 |
S. pneumonia ATCC 49619 |
25-30 |
REFERENCES
1. Clinical and Laboratory Standards Institute.Method for
Dilution Antimicrobial Susceptibility Tests for Bacteria that Grow Aerobically,
7th ed. Approved Standard CLSI Document M07A7, Vol. 26(2). CLSI, Wayne, PA,
Jan. 2006.
2. Clinical and Laboratory Standards Institute.Performance
Standards for Antimicrobial Susceptibility Testing, 18th Informational
Supplement, CLSI Document M100-S18, Vol 28(1). CLSI, Wayne, PA, Jan. 2008.