DOSAGE AND ADMINISTRATION
For intravenous use after reconstitution only.
Dosing Guidelines
- Dose and duration of treatment depend on the severity of
the Factor VIII deficiency, the location and extent of bleeding, and the
patient's clinical condition. Careful monitoring of replacement therapy is
necessary in cases of major surgery or life-threatening bleeding episodes.
- Each vial label of ELOCTATE states the Factor VIII
potency in international units (IU). One IU corresponds to the activity of
Factor VIII contained in one milliliter of normal human plasma.
- Potency assignment is determined using a chromogenic
substrate assay. A field study1 has indicated that plasma Factor VIII levels
can be monitored using either a chromogenic substrate assay or a one stage
clotting assay routinely used in US clinical laboratories.
- Calculation of the required dose of Factor VIII is based
on the empirical finding that 1 IU of Factor VIII per kg body weight raises the
plasma Factor VIII level by 2 IU/dL. The expected in vivo peak increase in
Factor VIII level expressed as IU/dL (or % of normal) is estimated using the
following formula:
Estimated Increment of Factor VIII (IU/dL or % of
normal) = [Total Dose (IU)/body weight (kg)] x 2 (IU/dL per IU/kg)
The dose to achieve a desired in vivo peak increase in
Factor VIII level may be calculated using the following formula:
Dose (IU) = body weight (kg) x Desired Factor VIII
Rise (IU/dL or % of normal) x 0.5 (IU/kg per IU/dL)
- Patients may vary in their pharmacokinetic (e.g.,
half-life, in vivo recovery) and clinical responses. Base the dose and
frequency of ELOCTATE on the individual clinical response.
- Dose adjustment may be necessary in pediatric patients
under six years of age [see Use In Specific Populations]. For patients
six years of age or older, dose adjustment is not usually required.
Control and Prevention of Bleeding Episodes
A guide for dosing ELOCTATE for the control and
prevention of bleeding episodes is provided in Table 1. Consideration should be
given to maintaining a Factor VIII activity at or above the target range.
Table 1: Dosing for Control and Prevention of Bleeding
Episodes
Type of Bleeding |
Factor VIII Level Required (IU/dL or % of normal) |
Dose (IU/kg) |
Frequency of Dosing (hours) |
Duration of Therapy (days) |
Minor and Moderate Joint, superficial muscle/no neurovascular compromise (except iliopsoas), deep laceration and renal, superficial soft tissue, mucous membranes |
40-60 |
20-30 |
Repeat every 24-48 hours (12 to 24 hours for patients less than 6 years of age) |
Until the bleeding episode is resolved |
Major Life or limb threatening hemorrhage, iliopsoas and deep muscle with neurovascular injury, retroperitoneum, intracranial, or gastrointestinal |
80-100 |
40-50 |
Repeat every 12-24 hours (8 to 24 hours for patients less than 6 years of age) |
Until bleeding is resolved (approximately 7-10 days) |
Perioperative Management
A guide for dosing ELOCTATE during surgery (perioperative
management) is provided in Table 2. Consideration should be given to
maintaining a Factor VIII activity at or above the target range.
Table 2: Dosing for Perioperative Management
Type of Surgery |
Factor VIII Level Required (IU/dL or % of normal) |
Dose (IU/kg) |
Frequency of Dosing (hours) |
Duration of Therapy (days) |
Minor Uncomplicated tooth extraction |
50-80 |
25-40 |
Repeat every 24 hours (12-24 hours for patients less than 6 years of age) |
At least 1 day until healing is achieved |
Major Intracranial, intra-abdominal, or joint replacement surgery |
80-120 (pre- and postoperative) |
Preoperative: 40-60 Repeat: 40-50 |
Pre-operative dose of 40 to 60 IU/kg followed by a repeat dose of 40-50 IU/kg after 8-24 hours (6 to 24 for patients less than 6 years of age) and then every 24 hours to maintain FVIII activity within the target range |
Until adequate wound healing, then continue therapy for at least 7 days to maintain a Factor VIII activity within the target range |
Routine Prophylaxis
- The recommended starting regimen is 50 IU/kg of ELOCTATE
administered every 4 days.
- The regimen may be adjusted based on patient response with
dosing in the range of 25-65 IU/kg at 3-5 day intervals. More frequent or
higher doses up to 80 IU/kg may be required in children less than 6 years of
age. [see CLINICAL PHARMACOLOGY]
Preparation And Reconstitution
1. Use aseptic technique (clean and germ free) and a flat
work surface during the reconstitution procedure.
2. Allow the vial of ELOCTATE and pre-filled diluent
syringe to reach room temperature before use.
3. Remove the plastic cap from the vial and wipe the
rubber stopper of the vial with an alcohol wipe. Allow the rubber stopper to
dry.
4. Completely remove the backing from the vial adapter
package by peeling back the lid. Do not remove the vial adapter from the
package or touch the inside of the package of the adapter.
5. Place the vial on a flat and solid surface and use one
hand to hold the vial steady. Use the other hand to place the vial adapter over
the vial. Place the adapter spike directly above the center of the rubber
stopper and push the adapter straight down until the spike punctures the center
of the vial stopper and is fully inserted.
6. Lift the package cover away from the vial adapter and
discard the cover.
7. Hold the plunger rod at the circular disk. Place the
tip of the plunger rod into the end of the syringe. Turn clockwise until it is
securely attached. Only use the diluent syringe provided in the ELOCTATE
package.
8. With one hand, hold the diluent syringe by the ridged
part directly under the cap, with the cap pointing up. Do not use if the cap
has been removed or is not securely attached.
9. With your other hand, grasp the cap and bend it at a
90° angle until it snaps off. After the cap snaps off, you will see the glass
tip of the syringe. Do not touch the glass tip of the syringe or the inside of
the cap.
10. With the vial sitting on a flat surface, insert the
tip of the syringe into the adapter opening. Turn the syringe clockwise until
it is securely attached to the adapter.
11. Slowly depress the plunger rod to inject all of the
diluent into the vial. The plunger rod may rise slightly after this process.
This is normal.
12. With the syringe still connected to the adapter,
gently swirl the vial until the product is completely dissolved. Do not shake.
The reconstituted solution should be clear to slightly opalescent and
colorless. Do not use the reconstituted ELOCTATE if it contains visible
particles or is cloudy.
13. Make sure the plunger rod is completely depressed.
Turn the vial upside-down. Slowly pull on the plunger rod to draw the solution
into the syringe. Be careful not to pull the plunger rod completely out of the
syringe.
14. Gently unscrew the syringe from the vial adapter and
dispose of the vial with the adapter still attached. Do not touch the syringe
tip or the inside of the cap.
15. Use the reconstituted ELOCTATE as soon as possible,
but no later than 3 hours after reconstitution. Do not touch the glass tip of
the syringe if not used immediately after reconstitution. Protect from direct
sunlight. Do not refrigerate after reconstitution.
To combine two or more vials of ELOCTATE, after step 12
above, follow these pooling steps:
- Remove the diluent syringe from the vial adapter by turning
it counterclockwise until it is completely detached.
- Leave the vial adapter attached to the vial, as it is
needed for attaching a large luer lock syringe (not included in kit). Do not
detach the diluent syringe until ready to attach the large luer-lock syringe.
- Attach a separate, large luer-lock syringe by turning
clockwise until it is securely in place.
- Slowly pull on the plunger rod to draw the solution into
the syringe.
- Repeat this pooling procedure with each vial that is
needed to obtain the required dose. When pooling, do not detach the large
luer-lock syringe until ready to attach it to the next vial (with vial adapter
attached). Once you have pooled the required dose, proceed to administration
using the large luer-lock syringe.
Administration
For Intravenous Injection Only
- Inspect the reconstituted ELOCTATE solution visually for
particulate matter and discoloration prior to administration. Do not use if
particulate matter or discoloration is observed.
- Do not administer reconstituted ELOCTATE in the same
tubing or container with other medications.
Administration Steps
- Attach the syringe to the connector end of the infusion
set tubing by turning clockwise until it is securely in place.
- Depress the plunger until all air is removed from the
syringe and ELOCTATE has reached the end of the infusion set tubing. Do not
push ELOCTATE solution through the needle.
- Remove the protective needle cover from the infusion set
tubing.
- Perform intravenous bolus infusion. The rate of
administration should be determined by the patient's comfort level, and no
faster than 10 ml per minute. After infusing ELOCTATE, remove and properly
discard the infusion set.
HOW SUPPLIED
Dosage Forms And Strengths
ELOCTATE is available as a lyophilized powder in single
use vials containing nominally 250, 500, 750, 1000, 1500, 2000, or 3000
international units (IU) per vial. The actual Factor VIII potency is labeled on
each ELOCTATE vial.
ELOCTATE is supplied in kits comprising a single use vial
containing nominally, 250, 500, 750, 1000, 1500, 2000, or 3000 international
units (IU) of Factor VIII potency, a pre-filled syringe with 3 mL sterile water
for injection, and a sterile vial adapter (reconstitution device). The actual
amount of ELOCTATE in IU is stated on the label and carton of each vial.
Strength |
Kit NDC Number |
250 IU |
64406-801-01 |
500 IU |
64406-802-01 |
750 IU |
64406-803-01 |
1000IU |
64406-804-01 |
1500IU |
64406-805-01 |
2000IU |
64406-806-01 |
3000 IU |
64406-807-01 |
Storage And Handling
Prior To Reconstitution
- Store ELOCTATE in the original package to protect the
ELOCTATE vials from light.
- Store ELOCTATE in powder form at 2°C to 8°C (36°F to
46°F). Do not freeze to avoid damage to the pre-filled diluent syringe.
- ELOCTATE may be stored at room temperature, not to exceed
30°C (86°F), for a single period of up to 6 months, within the expiration date
printed on the label.
- If stored at room temperature, record the date that
ELOCTATE is removed from refrigeration on the carton in the area provided.
After storage at room temperature, do not return the product to the
refrigerator.
- Do not use beyond the expiration date printed on the vial
or 6 months after the date that was written on the carton, whichever is
earlier.
After Reconstitution
- The reconstituted product may be stored at room
temperature, not to exceed 30°C (86°F), for up to 3 hours. Protect from direct
sunlight. After reconstitution, if the product is not used within 3 hours, it
must be discarded.
- Do not use ELOCTATE if the reconstituted solution is
cloudy or has particulate matter.
- Discard any unused ELOCTATE.
Manufactured by: Biogen Idec Inc., 14 Cambridge Center, Cambridge,
MA 02142 USA. Revised: June 2014