You are here
Home > Dilution > Ferric Carboxymaltose-Injectafer®

Ferric Carboxymaltose-Injectafer®

INJECTAFER® (ferric carboxymaltose injection)
[ Usual Diluents ] [ Standard Dilution ] [ Storage and Stability ]
DESCRIPTION CLINICAL PHARMACOLOGY INDICATIONS AND USAGE
CONTRAINDICATIONS PRECAUTIONS ADVERSE REACTIONS
DOSAGE AND ADMINISTRATION HOW SUPPLIED WARNINGS
PRESCRIBING HIGHLIGHTS: Please see package insert for additional information and possible updates to ensure safe and effective use of this medication. The authors make no claims of the accuracy of the information contained herein; and these suggested doses are not a substitute for clinical judgment. Neither GlobalRPh Inc. nor any other party involved in the preparation of this program shall be liable for any special, consequential, or exemplary damages resulting in whole or part from any user's use of or reliance upon this material. Please read the disclaimer carefully BEFORE accessing or using this site. BY ACCESSING OR USING THIS SITE, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS SET FORTH IN THE DISCLAIMER.
Iron supplements - other

Usual Diluents top of page
NS

Standard Dilutions [Amount of drug] [Infusion volume] [Infusion rate] top of page
[Patients weighing 50 kg (110 lb) or more ] May administer undiluted slow intravenous push at ~ 100mg/min. [750mg] [15 ml] [~7.5 minutes]

Give Injectafer in two doses separated by at least 7 days. Give each dose as 750 mg for a total cumulative dose not to exceed 1500 mg of iron per course.

-OR- Administer via infusion, dilute up to 750 mg of iron in no more than 250 mL of sterile 0.9% sodium chloride injection, USP, such that the concentration of the infusion is in the range of 2 mg to 4 mg of iron per mL. [750mg] [250 ml] [15-20 minutes] Each mL of Injectafer contains 50 mg of elemental iron.

[Patients weighing LESS than 50 kg (110 lb) ] May administer undiluted slow intravenous push at ~ 100mg/min. [15mg/kg ] [dose (ml)= (15mg/kg) / 50 ] [~7.5 minutes]

Give Injectafer in two doses separated by at least 7 days. Give each dose as 15 mg/kg body weight for a total cumulative dose not to exceed 1500 mg of iron per course.

-OR- Administer via infusion, dilute up to 750 mg of iron in no more than 250 mL of sterile 0.9% sodium chloride injection, USP, such that the concentration of the infusion is in the range of 2 mg to 4 mg of iron per mL. [15 mg/kg] [250 ml] [15-20 minutes]

Stability: When added to an infusion bag containing 0.9% sodium chloride injection, USP, at concentrations ranging from 2 mg to 4 mg of iron per mL, Injectafer solution is physically and chemically stable for 72 hours when stored at room temperature. To maintain stability, do not dilute to concentrations less than 2 mg iron/mL.Inspect parenteral drug products visually for the absence of particulate matter and discoloration prior to administration. The product contains no preservatives. Each vial of Injectafer is intended for single-use only. Any unused drug remaining after injection must be discarded.

Avoid extravasation of Injectafer since brown discoloration of the extravasation site may be long lasting. Monitor for extravasation. If extravasation occurs, discontinue the Injectafer administration at that site.

WARNINGS top of page
See warnings and precautions below.

DESCRIPTION top of page
Description: Ferric carboxymaltose, an iron replacement product, is an iron carbohydrate complex with the chemical name of polynuclear iron (III) hydroxide 4(R)-(poly-(1?4)-O-a-D-glucopyranosyl)-oxy-2(R),3(S),5(R),6-tetrahydroxy-hexanoate. It has a relative molecular weight of approximately 150,000 Da corresponding to the following empirical formula: [FeOx(OH)y(H2O)z]n [{(C6H10O5)m (C6H12O7)}l]k, where n ˜ 103, m ˜ 8, l ˜ 11, and k ˜ 4 (l represents the mean branching degree of the ligand). Injectafer (ferric carboxymaltose injection) is a dark brown, sterile, aqueous, isotonic colloidal solution for intravenous injection. Each mL contains 50 mg iron as ferric carboxymaltose in water for injection. Injectafer is available in 15 mL single-use vials. Sodium hydroxide and/or hydrochloric acid may have been added to adjust the pH to 5.0-7.0. Vial closure is not made with natural rubber latex.

CLINICAL PHARMACOLOGY: top of page
Mechanism of Action: Ferric carboxymaltose is a colloidal iron (III) hydroxide in complex with carboxymaltose, a carbohydrate polymer that releases iron.

INDICATIONS AND USAGE top of page
INDICATIONS AND USAGE: Injectafer is indicated for the treatment of iron deficiency anemia in adult patients: >who have intolerance to oral iron or have had unsatisfactory response to oral iron; >who have non-dialysis dependent chronic kidney disease. USE IN SPECIFIC POPULATIONS -------------- Pregnancy Pregnancy Category C Risk Summary Adequate and well controlled studies in pregnant women have not been conducted. However, animal reproduction studies have been conducted with ferric carboxymaltose. In these studies, administration of ferric carboxymaltose to rabbits during the period of organogenesis caused fetal malformations and increased implantation loss at maternally toxic doses of approximately 12% to 23% of the human weekly dose of 750 mg (based on body surface area). The incidence of major malformations in human pregnancies has not been established for Injectafer. However, all pregnancies, regardless of exposure to any drug, has a background rate of 2 to 4% for major malformations, and 15 to 20% for pregnancy loss. Injectafer should be used during pregnancy only if the potential benefit justifies the potential risk to the fetus. Animal Data Administration of ferric carboxymaltose to rats as a one-hour intravenous infusion up to 30 mg/kg/day iron on gestation days 6 to 17 did not result in adverse embryofetal findings. This daily dose in rats is approximately 40% of the human weekly dose of 750 mg based on body surface area. In rabbits, ferric carboxymaltose was administered as a one-hour infusion on gestation days 6 to 19 at iron doses of 4.5, 9, 13.5, and 18 mg/kg/day. Malformations were seen starting at the daily dose of 9 mg/kg (23% of the human weekly dose of 750 mg). Spontaneous abortions occurred starting at the daily iron dose of 4.5 mg/kg (12% of the human weekly dose based on body surface area). Pre-implantation loss was at the highest dose. Adverse embryofetal effects were observed in the presence of maternal toxicity. A pre- and post-natal development study was conducted in rats at intravenous doses up to 18 mg/kg/day of iron (approximately 23% of the weekly human dose of 750 mg on a body surface area basis). There were no adverse effects on survival of offspring, their behavior, sexual maturation or reproductive parameters. Nursing Mothers A study to determine iron concentrations in breast milk after administration of Injectafer (n=11) or oral ferrous sulfate (n=14) was conducted in 25 lactating women with postpartum iron deficiency anemia. Mean breast milk iron levels were higher in lactating women receiving Injectafer than in lactating women receiving oral ferrous sulfate. Pediatric Use Safety and effectiveness have not been established in pediatric patients. Geriatric Use Of the 1775 subjects in clinical studies of Injectafer, 50% were 65 years and over, while 25% were 75 years and over. No overall differences in safety or effectiveness were observed between these subjects and younger subjects, and other reported clinical experience has not identified differences in responses between the elderly and younger patients, but greater sensitivity of some older individuals cannot be ruled out.

CONTRAINDICATIONS top of page
Contraindications: Hypersensitivity to Injectafer or any of its inactive components.

PRECAUTIONS top of page
WARNINGS AND PRECAUTIONS:

  1. Hypersensitivity Reactions Serious hypersensitivity reactions, including anaphylactic-type reactions, some of which have been life-threatening and fatal, have been reported in patients receiving Injectafer. Patients may present with shock, clinically significant hypotension, loss of consciousness, and/or collapse. Monitor patients for signs and symptoms of hypersensitivity during and after Injectafer administration for at least 30 minutes and until clinically stable following completion of the infusion. Only administer Injectafer when personnel and therapies are immediately available for the treatment of serious hypersensitivity reactions. [see Adverse Reactions ]. In clinical trials, serious anaphylactic/anaphylactoid reactions were reported in 0.1% (2/1775) of subjects receiving Injectafer. Other serious or severe adverse reactions potentially associated with hypersensitivity which included, but not limited to, pruritus, rash, urticaria, wheezing, or hypotension were reported in 1.5% (26/1775) of these subjects.
  2. Hypertension In clinical studies, hypertension was reported in 3.8% (67/1,775) of subjects in clinical trials 1 and 2. Transient elevations in systolic blood pressure, sometimes occurring with facial flushing, dizziness, or nausea were observed in 6% (106/1,775) of subjects in these two clinical trials. These elevations generally occurred immediately after dosing and resolved within 30 minutes. Monitor patients for signs and symptoms of hypertension following each Injectafer administration [see Dosage and Administration].
  3. Laboratory Test Alterations In the 24 hours following administration of Injectafer, laboratory assays may overestimate serum iron and transferrin bound iron by also measuring the iron in Injectafer.

ADVERSE REACTIONS top of page
ADVERSE REACTIONS:

  • The most common adverse reactions (≥ 2%) are nausea, hypertension, flushing, hypophosphatemia, and dizziness. To report SUSPECTED ADVERSE REACTIONS, contact American Regent at 1-800-734-9236 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch.

See PACKAGE INSERT for PATIENT COUNSELING INFORMATION and Medication Guide.

DOSAGE AND ADMINISTRATION top of page
DOSAGE AND ADMINISTRATION:

For patients weighing 50 kg (110 lb) or more:  Give Injectafer in two doses separated by at least 7 days.  Give each dose as 750 mg for a total cumulative dose not to exceed 1500 mg of iron per course.

For patients weighing less than 50 kg (110 lb):  Give Injectafer in two doses separated by at least 7 days. Give each dose as 15 mg/kg body weight for a total cumulative dose not to exceed 1500 mg of iron per course. 

The dosage of Injectafer is expressed in mg of elemental iron. Each mL of Injectafer contains 50 mg of elemental iron.  Injectafer treatment may be repeated if iron deficiency anemia reoccurs.  

Administer Injectafer intravenously, either as an undiluted slow intravenous push or by infusion.  When administering as a slow intravenous push, give at the rate of approximately 100 mg (2 mL) per minute.  When administered via infusion, dilute up to 750 mg of iron in no more than 250 mL of sterile 0.9% sodium chloride injection, USP, such that the concentration of the infusion is not less than 2 mg of iron per mL and administer over at least 15 minutes.

When added to an infusion bag containing 0.9% sodium chloride injection, USP, at concentrations ranging from 2 mg to 4 mg of iron per mL, Injectafer solution is physically and chemically stable for 72 hours when stored at room temperature.  To maintain stability, do not dilute to concentrations less than 2 mg iron/mL.

Inspect parenteral drug products visually for the absence of particulate matter and discoloration prior to administration.  The product contains no preservatives. Each vial of Injectafer is intended for single-use only. Any unused drug remaining after injection must be discarded.

Avoid extravasation of Injectafer since brown discoloration of the extravasation site may be long lasting.  Monitor for extravasation.  If extravasation occurs, discontinue the Injectafer administration at that site.

HOW SUPPLIED top of page
DOSAGE FORMS AND STRENGTHS: 750 mg iron/15 mL single-use vial. NDC 0517-0650-01 750 mg iron/15 mL Single-Use Vial Individually boxed NDC 0517-0650-02 750 mg iron/15 mL Single-Use Vial Packages of 2

Storage and Stability top of page
Store at 20°C to 25°C (68°F to 77°F); excursions permitted to 15°C to 30°C (59°F to 86°F). [See the USP controlled room temperature]. Do not freeze. Admixture stability: When added to an infusion bag containing 0.9% sodium chloride injection, USP, at concentrations ranging from 2 mg to 4 mg of iron per mL, Injectafer solution is physically and chemically stable for 72 hours when stored at room temperature. To maintain stability, do not dilute to concentrations less than 2 mg iron/mL
Ferric Carboxymaltose-Injectafer®

thpxl