VIMPAT® (lacosamide) Injection for Intravenous use |
|
The authors make no claims of the accuracy of the information contained herein; and these suggested doses and/or guidelines are not a substitute for clinical judgment. Neither GlobalRPh Inc. nor any other party involved in the preparation of this document shall be liable for any special, consequential, or exemplary damages resulting in whole or part from any user's use of or reliance upon this material. PLEASE READ THE DISCLAIMER CAREFULLY BEFORE ACCESSING OR USING THIS SITE. BY ACCESSING OR USING THIS SITE, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS SET FORTH IN THE DISCLAIMER. | |
Usual Diluents |
|
Ready-to-use. May further dilute if desired with: NS, D5W, or LR |
|
Standard Dilution [Amount of drug] [Infusion volume] [Infusion rate] |
|
[Prescribed dose] [Ready-to-use solution: 10 mg/ml ] [30 - 60 minutes] | |
Stability / Miscellaneous |
|
Compatibility and Stability VIMPAT injection can be administered intravenously without further dilution or may be mixed with diluents. VIMPAT injection was found to be physically compatible and chemically stable when mixed with the following diluents for at least 4 hours and stored in glass or polyvinyl chloride (PVC) bags at ambient room temperature 15-30°C (59-86°F). Diluents: The stability of VIMPAT injection in other infusion solutions has not been evaluated. Product with particulate matter or discoloration should not be used. Storage (vials): Do not freeze Vimpat injection or oral solution. Discard any unused Vimpat oral solution remaining after seven (7) weeks of first opening the bottle.
CLINICAL PHARMACOLOGY Lacosamide binds to collapsin response mediator protein-2 (CRMP-2), a phosphoprotein which is mainly expressed in the nervous system and is involved in neuronal differentiation and control of axonal outgrowth. The role of CRMP-2 binding in seizure control is unknown. Pharmacokinetics VIMPAT is completely absorbed after oral administration with negligible first-pass effect with a high absolute bioavailability of approximately 100%. The maximum lacosamide plasma concentrations occur approximately 1 to 4 hour post-dose after oral dosing, and elimination half-life is approximately 13 hours. Steady state plasma concentrations are achieved after 3 days of twice daily repeated administration. Pharmacokinetics of VIMPAT are dose proportional (100-800 mg) and time invariant, with low inter- and intra-subject variability. Compared to lacosamide the major metabolite, O-desmethyl metabolite, has a longer Tmax (0.5 to 12 hours) and elimination half-life (15-23 hours). Absorption and Bioavailability After intravenous administration, Cmax is reached at the end of infusion. The 30- and 60-minute intravenous infusions are bioequivalent to the oral tablet. In a trial comparing the oral tablet with and an oral solution containing 10 mg/mL lacosamide, bioequivalence between both formulations was shown. Distribution Metabolism and Elimination After oral and intravenous administration of 100 mg [14C]-lacosamide approximately 95% of radioactivity administered was recovered in the urine and less than 0.5% in the feces. The major compounds excreted were unchanged lacosamide (approximately 40% of the dose), its O-desmethyl metabolite (approximately 30%), and a structurally unknown polar fraction (~20%). The plasma exposure of the major human metabolite, O-desmethyl-lacosamide, is approximately 10% of that of lacosamide. This metabolite has no known pharmacological activity. Lacosamide is a CYP2C19 substrate. The relative contribution of other CYP isoforms or non-CYP enzymes in the metabolism of lacosamide is not clear. The elimination half-life of the unchanged drug is approximately 13 hours and is not altered by different doses, multiple dosing or intravenous administration. INDICATIONS AND USAGE DOSAGE AND ADMINISTRATION Oral-Intravenous Replacement therapy: When switching from oral VIMPAT, the initial total daily intravenous dosage of VIMPAT should be equivalent to the total daily dosage and frequency of oral VIMPAT. At the end of the intravenous treatment period, the patient may be switched to VIMPAT oral administration at the equivalent daily dosage and frequency of the intravenous administration. Switching from Oral to Intravenous Dosing Compatibility and Stability Diluents: The stability of VIMPAT injection in other infusion solutions has not been evaluated. Product with particulate matter or discoloration should not be used. Patients with Renal Impairment -------------------- Patients with Hepatic Impairment -------------------- DOSAGE FORMS AND STRENGTHS:
CONTRAINDICATIONS: WARNINGS AND PRECAUTIONS:
ADVERSE REACTIONS To report SUSPECTED ADVERSE REACTIONS, contact UCB, Inc. at 1-800-477-7877 or FDA at 1-800-FDA-1088 or www.fda.gov/medwatch USE IN SPECIFIC POPULATIONS
Storage (vials): Do not freeze Vimpat injection or oral solution. Discard any unused Vimpat oral solution remaining after seven (7) weeks of first opening the bottle. |
|
Reference(s) |
|
Package insert: 200 mg / 20 mL Vial Label NDC 0131-1810-67 VIMPAT® 200 mg /20 mL (10 mg/mL) |